TAPTITE 2000® CA Fasteners
Download TAPTITE 2000® PDF 
Section view shows hole-finding
capability of CA Point.The CA point can be supplied with a sharp point or a slightly truncated
blunt point – which is desirable for situations when the sharp point
could be a potential hazard to wires, components or assembly line and
service personnel.
TAPTITE 2000® CA fasteners have a gimlet point
for use when clearance holes and pilot holes do not align.
The CA point is also good for rapid hole finding, floating nut members
or difficult access applications.
TAPTITE
2000® CA fasteners can be produced with any of
our heat treatment processes; case hardened – our standard heat
treatment for sizes M5 (#12) or smaller, CORFLEX®-I induction hardened for structural or demanding applications or CORFLEX®-N,
neutral hardened non-ferrous applications.
TAPTITE 2000® Fasteners | TAPTITE 2000® "SP"™ Fasteners | Fastener Heat Treatment | Back
